Real Alliance Memory AS4C4M16SA-6TIN datasheet (Rev 5.0, Table 17)
specifies tMRD as a fixed 2-tCK cycle count, not an ns value.
sdram_controller.v modeled it via ns_to_cycles(12), which rounded to
2 cycles by coincidence at every previously-tested frequency
(100/133/166MHz) but rounds to only 1 cycle at the real 64MHz board
target -- an under-provisioned one-time init sequence. Fixed by
hardcoding T_MRD=2, matching how CAS_LATENCY is already modeled.
Verified zero regression: full 9-config legacy sweep + a new
dedicated 64MHz config (461/461 PASS each), N=2/N=4 D-Stress
(identical cycle counts), board-level smoke test (11/11 PASS).
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_013xXuuRUWZScuo1DeYJxs3v
FASE #1 hardware freeze for FPGA-Neural V2, N4/P8, single external
SDRAM (Alliance Memory AS4C4M16SA-6TIN) serving weights, activations,
and results through one physical sdram_controller.v instance. Removes
the PSRAM dependency (hardware/v1/rtl/psram_controller.v +
memory_interface.v) from the V2 physical path entirely -- V1 itself
remains fully unmodified, the golden reference.
New RTL: sdram_unified_backend.v (2-way W/AR arbitration over one
SDRAM controller, real per-byte DQM write masking added to
sdram_controller.v for correct single-byte result writes with no
read-modify-write), nms_neural_multiprocessor_sdram_unified.v (the
frozen top-level). Two real bugs found and fixed via full-system
testing before being accepted (ERR-0023): a deadlock and an off-by-one
data-shift bug in the new arbitration logic.
Real results: N=4 and N=2 D-Stress bit-exact (256/256 neurons), 40
real AUTO REFRESH events interleaved with zero corruption, real
Yosys+nextpnr-ecp5 synthesis/P&R for LFE5U-45F-8CABGA381 (149/245
TRELLIS_IO, a real 45-pin reduction from the prior dual-memory
design). Timing is MARGINAL (1/8 P&R seeds >=80MHz), reported honestly
rather than masked by the best seed.
Real, sourced ball-level pinout for the SDRAM bus + clk/rst (39/149
signals, P&R-verified) using the official Lattice ECP5U-45 pinout CSV
found on disk during this step's own pre-commit review -- corrects an
earlier draft that wrongly assumed no real pinout data was available.
Chip readiness: NO. Real, disclosed blockers remain (no physical host
interface exists yet -- the RTL's own reg_* ports are a 110-pin raw
test-harness bus; clock source/PLL decision; power/configuration
component selection) -- see hardware/v2/docs/{HARDWARE_FREEZE,
CHIP_READINESS,OPEN_ITEMS}.md for the complete, itemized status.
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_013xXuuRUWZScuo1DeYJxs3v
micheleandClaude Sonnet 5