BT1035 boot can fail with total UART silence even after the banner-timing
fix, on otherwise-identical, correctly-powered hardware. Confirmed via
multimeter (VBAT_IN, 1.8V_OUT, SYS_CTRL/RESET, TX all normal) and by
observing the same physical module both succeed and fail across different
boot attempts in one session, that this is intermittent, not a dead
module — the crystal is sealed inside the module and not inspectable or
fixable from our side.
Since the fault self-clears on a later attempt, mitigate with an
indefinite background retry task: if the initial boot() fails, keep
retrying with no artificial delay (each attempt already takes ~25-60s) so
a temporary failure becomes a bounded, self-recovering delay instead of
requiring a manual power cycle. Documented the full diagnostic session,
including the ruled-out theories and a possible future ESP32-S31 (native
Bluetooth Classic) migration path, in the RF investigation report.
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
micheleandClaude Sonnet 5
f6dc9916a4