micheleandClaude Sonnet 5
55c827bedf
PSRAM page-mode read burst support in psram_controller.v: enables the ISSI IS66WVE4M16EBLL-70BLI's page mode via its configuration-register software-access sequence at boot (disabled by default on the real chip), then keeps CE#/OE# asserted after a read so a same-page continuation only pays tAPA (20ns) instead of a full tAA (70ns) random access, with automatic tCEM-safe session closing. Only a WRITE closes the page -- byte-enable changes do not, since int8_memory_access.v alternates them on nearly every access and an early implementation attempt that treated them as a close condition measured a real regression (53.25->61.25 cycles/edge) before being corrected (53.25->37.53 cycles/edge, +42% gather bandwidth). sim/psram_model.v gained independent tAPA/tAA and tCEM enforcement (with a real Verilog same-timestep event-ordering race found and fixed via a #0 sync) so the regression proves real timing compliance, not just data correctness. New sim/psram_page_mode_tb.v; full 26-file regression suite re-run clean. Real nextpnr-ecp5 Fmax re-measured on the full spi_neuron_top system: 75.73MHz (P2, up from 55.59MHz) and 65.13MHz (P8) -- still under the 80MHz target but not regressed, with the critical path confirmed (not assumed) to remain entirely inside neuron_parallel's accumulate chain, never psram_controller. Also includes this session's other already-validated work: the graph engine (Type #2 sparse-graph network: act_buffer, graph_engine, netasm host assembler), real CABGA381 pinout (.lpf, place&route verified) and physical IRQ_N/DATA_READY_N pins, and Phase 7 timing closure logs -- all previously uncommitted, documented in WORKLOG.md. Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_01LH3jPeJ3eFMfF2v8SQhpkk
14 lines
386 B
Plaintext
14 lines
386 B
Plaintext
; Worked example from the project spec (§3): 4 inputs, two neurons,
|
|
; n5 is the sole output. See docs for the hand-computed expected
|
|
; result with x = [10, 1, 4, 0]: n4=49, n5=126.
|
|
NET graph
|
|
INPUTS 4 ; id 0..3
|
|
NEURON n4 relu bias=2
|
|
CONN 0 w=5
|
|
CONN 1 w=-3
|
|
NEURON n5 none bias=0
|
|
CONN n4 w=2 ; symbolic reference to n4's output
|
|
CONN 2 w=7
|
|
OUTPUT n5
|
|
END
|