micheleandClaude Sonnet 5
8af16d3a12
Implements M6: dependency_manager.v tracks a table of node
descriptors (node_id/state/required_dependencies/resolved_
dependencies/producer_ids -- §10's exact field list), incrementing a
waiting node's resolved count whenever one of its listed producers
completes, transitioning it to READY once resolved==required, and
dispatching ready nodes to the Neural Director (M5) one at a time via
a backpressure-safe valid/ready interface.
Verified with Verilator on a small hand-built DAG: node0/node1 have no
dependencies (dispatch immediately); node2 depends on BOTH node0 AND
node1 ("dipendenze multiple") and stays WAITING until both complete,
confirmed via an explicit negative check after only one resolves;
node3 depends on node0 ALONE, demonstrating a single producer
("node0") satisfying two different consumers' dependencies
("risultati condivisi... piu' consumer") -- node3 fully, node2
partially. 4/4 tests pass.
Scope for this milestone (decisions.log DEC-0008): dependency
COUNTING/readiness only, no direct producer-to-consumer value
forwarding (§11 frames that as a "quando possibile" optimization, not
a correctness requirement -- deferred until real bandwidth
measurements justify it) and no node-slot reclamation after dispatch
(not exercised by any scenario built so far).
Real synthesis: 0 CHECK problems, 763 LUT4/474 FF/0 DSP/0 CCU2C. Real
place&route (module fits the TRELLIS_IO budget as a bare top-level
this time, no harness needed): Fmax 155.30 MHz, PASS at 80MHz.
Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_013xXuuRUWZScuo1DeYJxs3v
91 lines
4.7 KiB
Plaintext
91 lines
4.7 KiB
Plaintext
# V2 benchmark log -- solo append, mai troncato/sovrascritto (vedi README.md)
|
|
# Nessuna entry ancora -- popolato incrementalmente man mano che avanza lo sviluppo V2.
|
|
|
|
[2026-09-05] M1 single Neural Processor, isolated (no array/director/
|
|
memory manager yet -- system-level numbers deferred to M9)
|
|
|
|
| Config | Fmax (POST-P&R) | LUT | FF | DSP | BRAM |
|
|
|----------------------|------------------|-----|-----|-----|------|
|
|
| P_IN=8, ACC_WIDTH=32 | 183.12 MHz | 55 | 533 | 8 | 0 |
|
|
| P_IN=8, ACC_WIDTH=24 | 176.21 MHz | 49 | 509 | 8 | 0 |
|
|
|
|
Reference (V1, hardware/v1/synthesis/p8/, isolated neuron_parallel,
|
|
PARALLEL=8, N_INPUTS=256): 61.71 MHz POST-P&R.
|
|
|
|
All Fmax figures above are POST-P&R (real nextpnr-ecp5), not
|
|
theoretical or simulated-only. MAC/cycle, cycles/neuron, neurons/s,
|
|
stall %, effective MAC/s: not yet meaningful at this milestone (single
|
|
isolated processor, no streaming benchmark harness yet -- deferred to
|
|
M2 once neural_processor_array.v exists and a real workload can be
|
|
timed end-to-end).
|
|
|
|
[2026-09-05] M2 Neural Processor Array, N_PROCESSORS sweep (P_IN=8,
|
|
ACC_WIDTH=32 each; synthesized via the timing harness, see errors.log
|
|
ERR-0005 for why)
|
|
|
|
| N_PROCESSORS | Fmax (POST-P&R) | LUT | FF | DSP (MULT18X18D) | DSP % of 72 |
|
|
|--------------|------------------|-----|------|-------------------|-------------|
|
|
| 1 | 159.11 MHz | 59 | 409 | 8 | 11% |
|
|
| 2 | 149.59 MHz | 106 | 786 | 16 | 22% |
|
|
| 4 | 151.01 MHz | 207 | 1540 | 32 | 44% |
|
|
| 8 | 134.70 MHz | 374 | 3048 | 64 | 88% |
|
|
|
|
All figures POST-P&R (real nextpnr-ecp5), all PASS at the 80MHz
|
|
target. LUT4 utilization stays under 6% of the device even at N=8;
|
|
DSP is the binding resource (see decisions.log DEC-0005), reaching 88%
|
|
at N=8 -- N_PROCESSORS=9 would already exceed the LFE5U-45F's 72
|
|
MULT18X18D budget at P_IN=8. Theoretical MAC/cycle (THEORETICAL, not
|
|
yet measured end-to-end -- no real workload/benchmark harness exists
|
|
until M9): N_PROCESSORS * P_IN MACs/cycle when all processors are
|
|
simultaneously streaming tiles (8, 16, 32, 64 for N=1/2/4/8 -- verified
|
|
achievable in principle by EXP-0003's concurrent/staggered simulation,
|
|
not yet measured as a sustained throughput number).
|
|
|
|
[2026-09-05] M3 buffers -- BRAM cost vs DEPTH (real Yosys synth_ecp5)
|
|
|
|
| Module | DEPTH | DP16KD | LUT4 | FF |
|
|
|--------------------|-------|--------|------|-----|
|
|
| activation_buffer | 4096 | 2 | 37 | 30 |
|
|
| activation_buffer | 256 | 1 | 21 | 26 |
|
|
| weight_buffer | 512 | 2 | 88 | 139 |
|
|
| weight_buffer | 64 | 2 | 73 | 136 |
|
|
| result_buffer | 4096 | 2 | 37 | 30 |
|
|
| result_buffer | 256 | 1 | 21 | 26 |
|
|
|
|
weight_buffer's DP16KD count is flat across an 8x depth reduction --
|
|
its 64-bit TILE_WIDTH (P_IN=8 * DATA_WIDTH=8), not DEPTH, determines
|
|
BRAM count for this module. activation_buffer/result_buffer (byte-
|
|
wide) scale as expected with depth. Confirms §14's warning literally:
|
|
"non assumere che buffer piu' grandi siano automaticamente migliori"
|
|
-- here, smaller was not cheaper either, because depth was the wrong
|
|
lever for this specific buffer's cost.
|
|
|
|
[2026-09-05] M4 Memory Manager + Prefetch Engine (standalone resource
|
|
count; Fmax via timing harness -- see errors.log ERR-0005)
|
|
|
|
| Module | Fmax (POST-P&R) | LUT | FF | DSP | CCU2C |
|
|
|----------------------------------|------------------|-----|-----|-----|-------|
|
|
| memory_manager + prefetch_engine | 165.86 MHz | 851 | 789 | 0 | 108 |
|
|
|
|
End-to-end (real PSRAM + real neural_processor, SIMULATED only, no
|
|
system-level P&R yet -- deferred to M7/M9): 3-tile job = 446 cycles,
|
|
1-tile job = 166 cycles, 5-tile job = 728 cycles. ~140-150 cycles/tile,
|
|
dominated by psram_model.v's real ~70ns TAA access latency, not by
|
|
memory_manager's own control overhead (its bank-swap turnaround is
|
|
documented as a fixed +1 cycle/tile in decisions.log DEC-0006, a small
|
|
fraction of the ~140-cycle PSRAM-dominated total).
|
|
|
|
[2026-09-05] M5 Neural Director (standalone resource count; Fmax via
|
|
timing harness -- see errors.log ERR-0005)
|
|
|
|
| Module | Fmax (POST-P&R) | LUT | FF | DSP | CCU2C |
|
|
|------------------|------------------|-----|-----|-----|-------|
|
|
| neural_director (N_SLOTS=4) | 250.50 MHz | 382 | 366 | 0 | 4 |
|
|
|
|
[2026-09-05] M6 Dependency Manager (real standalone synthesis + P&R,
|
|
no harness needed)
|
|
|
|
| Module | Fmax (POST-P&R) | LUT | FF | DSP | CCU2C |
|
|
|----------------------|------------------|-----|-----|-----|-------|
|
|
| dependency_manager (N_NODES=16) | 155.30 MHz | 763 | 474 | 0 | 0 |
|