micheleandClaude Sonnet 5
685a4d6cfe
New brief (N=8 timing closure, LFE5U-85F retarget, 4/8/16 x 1/2-bank SDRAM sweep). Phase 0: no RTL changes, only measure the current baseline. ERR-0030: constraints/v2_unified.lpf's FREQUENCY PORT "clk" was still 80MHz, a leftover from the STEP19 freeze, never updated to the project's real 64MHz target -- fixed (LPF only, zero RTL/datapath effect). ERR-0031 (bigger one): the first two synthesis attempts targeted nms_neural_multiprocessor_sdram_unified.v, which is NOT the real board-level top -- it's an obsolete wrapper only exercised by one testbench now. The real target is fpga_neural_v2_top.v (adds the real PLL, reset_sync, spi_host_bridge, and a second arbitration level), which is what actually goes through synthesis+P&R for hardware. Re-targeted correctly, matched against constraints/v2_board_top.lpf (all 17 ports real-ball-assigned). An N_SLOTS=8 P&R attempt against the WRONG (wrapper) target ran for 2h42m without converging on a single seed; discarded rather than trusted. N_SLOTS=8 baseline deferred by explicit user request until N_SLOTS=4 is fully understood -- re-attempt against the correct fpga_neural_v2_top target with an agreed time budget. Result (EXP-0049, fresh 8-seed nextpnr-ecp5 P&R, real pins): N_SLOTS=4 8/8 PASS at 64MHz, worst-seed 81.20MHz, mean 91.05MHz. Higher than DEC-0042's historical worst/best (64.55/77.21MHz) despite identical RTL -- disclosed, unresolved (leading hypothesis: nextpnr-ecp5 build/version difference), adopted as the operative baseline for this session's toolchain going forward. Full writeup in errors.log/timing.log/ experiments.log (EXP-0049). Co-Authored-By: Claude Sonnet 5 <noreply@anthropic.com>
Formato dei log V2
Regola non negoziabile (docs/v2-description.md §25-29): ogni attività
significativa (modifica, simulazione, sintesi, benchmark, decisione, errore)
deve essere registrata. Nessun log viene mai sovrascritto o troncato — solo
append. Nessun ID esperimento (EXP-XXXX) o decisione (DEC-XXXX) viene mai
riutilizzato, anche se il risultato è un FAIL.
File
development.log— log principale di sviluppo, un'entry per ogni sessione di lavoro/milestone (creazione file, refactor, avanzamento roadmap).architecture.log— decisioni e note di architettura a grana fine (non scelte finali — quelle vanno indecisions.log— ma esplorazioni, alternative considerate, vincoli scoperti).simulation.log— ogni run di simulazione (Icarus/Verilator): test, vettori, cicli, PASS/FAIL, confronto bit-exact con V1, stall/memory-wait.synthesis.log— ogni run Yosys: LUT/FF/DSP/BRAM, warning, problemi CHECK.timing.log— ogni run nextpnr-ecp5: Fmax, percorso critico, WNS/TNS se disponibili. Fmax "ufficiale" di una configurazione = solo da qui, mai da simulazione o stima.benchmark.log— tabelle di confronto per configurazione (Fmax, MAC/cycle, cycles/neuron, utilization, ecc.), sempre con etichetta THEORETICAL/SIMULATED/SYNTHESIZED/POST-P&R.decisions.log— decisioni architetturali importanti, formatoDEC-XXXX(vedidocs/v2-description.md§27).experiments.log— registro principale, unEXP-XXXXper ogni esperimento end-to-end (config → sim/synth/timing → risultato), rimanda areports/experiments/EXP-XXXX/.errors.log— errori/bug/regressioni incontrati durante lo sviluppo V2 stesso (non i bug V1, già chiusi inhardware/v1/docs/validation/bugs.md).
Campi minimi per entry (§26)
timestamp, experiment_id (se applicabile), git_commit, session/agent,
module, configuration, action, reason, command, result, errors, decision,
next_action
Per synthesis/timing aggiungere: LUT, FF, DSP, BRAM, Fmax, critical path, WNS/TNS. Per simulazione: test, vectors, cycles, PASS/FAIL, bit-exact result, stall cycles, memory wait, utilization.